- Country: Oman
- Summary: Fiberglass Tank Stand, Oty: 10
- OMT Ref No: 121851508
- Deadline: 14 Jul 2025
- Financier: Self Financed
- Purchaser Ownership: Government
- Tender Value: Refer Document
- Notice Type: Tender
- Document Ref. No.: 7038/25/0041
- Purchaser's Detail:Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details.
- Description:
- Category : Consumables
SQU Product Code : CONRESCEN2025
Description : Fiberglass Tank Stand
Quantity : 10
Remark : ο§Configuration: Single integrated stand supporting 1 row of 3 tanks.ο§Orientation: Tank stands are placed side by side in rows, each row has two stands (2 x 3 = 6 tanks).ο§Tank Spacing: Minimum 10 cm between tanks for access and airflowο§Main Material: Fiberglass Reinforced Plastic (FRP). Resin Type: Isophthalic polyester or vinyl ester resin for chemical and moisture resistance.ο§Surface Finish: Marine-grade gelcoat (light blue or light gray), smooth and easy to clean. The edges should be round. ο§Dimensions: Total length = 220 cm, Stand height from floor = 50 cm, Total width = 65-70 cm (enough to hold one row of tanks plus the pipe holder on the inner end of the tank stand. ο§Tank stand top deck: The top deck of the tank stand should have enough area for proper load distribution and prevent stress concentrations on small contact points of the tank. At the same time, it should allow for enough space for the drainage pipe. Example of the design: fiberglass sheet reinforced with ribs underneath. ο§Rubber or Foam sheet: placed under the tanks as a cushioning layer. ο§Load capacity: not less than 300 kg per tank position (900 kg total). Each tank stand needs to have a total of 8 stand legs (4 on each side). These legs are reinforced by internal ribbing and have spaces for drainage pipes with access space beneath each tank for drain fittings (bulkhead + pipe).ο§Air and Water Pipe Holder: Holder height above the tank stand = 50 cm. It is a vertical fiberglass holder located on the inside of the tank stand, anchored directly into the base stand for structural stability. Height (above tank stand) = ~80-90 cm. This rack will hold and support the airline and water inlet PVC pipes.
Invitation Date : 30/06/2025
Last Date Of Submission : 14/07/2025 - Documents:
If you are registered member, kindly login to view full details of this tender notice:
CLICK HERE TO LOGINFiberglass Tank Stand, Oty: 10 - Oman Tender
The SULTAN MARKS UNIVERSITY HOSPITAL, a Government sector organization in Oman, has announced a new tender for Fiberglass Tank Stand, Oty: 10. This tender is published on OmanTender under OMT Ref No: 121851508 and is categorized as a Tender. Interested and eligible suppliers are invited to participate by reviewing the tender documents and submitting their bids before the deadline on 2025-07-14.
The estimated tender value is Refer Document, and full details, including technical specifications and submission requirements, are provided in the official tender documents. Ensure all submissions meet the criteria outlined to be considered for evaluation.
